Genset mounting3004 viewsLeft side view of the genset rack. If I decide to continue using this setup, I'll probably rebuild the rack to look a LOT nicer, and paint it to match the Sparrow.
Rather than having a generator, I'd like to put about 2KWH worth of some lightweight battery in the rack. I just need more range to make it to work.
|
|
Genset mounting2823 viewsRight side view of the genset rack. Note that it is easy to remove the rack and restore the Sparrow to it's original look. It only takes 6 bolts to remove the rack and put the rear panel back in place.
|
|
Genset mounting2808 viewsWhat the genset looks like from the back.
|
|
Genset mounting2542 viewsThis is a view from above the back over the genset rack. The chain is to keep anyone from stealing the genset while I'm parked.
I do need to come up with a cover for the power outlet end of the genset. While it's meant for outdoor use, it's probably not expecting 60 mph rain to be hitting it...
|
|
PFC-40 Charger in back3739 viewsI currently have the PFC-40 Charger sitting in the back, since it is a LOT of work to make it fit under the hood.
The wood is just to make a flat bottom for the back area.
|
|
2473 views
|
|
MKIIC regs for under the seat batteries. (closeup)3101 viewsShows the regs in place. All the regs are mounted to a sheet of very flexible clear plastic. (Actually, the back of a big blister pac of something I bought). I then stuck strips of velcro hooks to the back of the plastic, and this lets me stick the assembly to the carpet.
|
|
MKIIC regs for under the seat batteries.2590 viewsThere are 7 MKIIC regs velcroed to the left side foot area. I put them here so I could see them, and it's hard to fit the MKIIC's under the seat.
|
|
MKIIC regs for the front batteries3817 viewsThis is how I mounted all the MKIIC regs for the front batteries. I used a sheet of clear plexiglass to hold all the regs.
|
|
3850 views
|
|
|
|
|
|
