1st half coupler on motor2867 viewsMounted 1/2 the coupler on the first motor.
|
|
2nd half coupler mounted2502 viewsMounted the other half the coupler on the other motor.
|
|
Putting them together3438 viewsBoth motors together! Bolted to the motor-motor mount.
|
|
Bolting coupler together3757 viewsWe hadn't realized just how difficult it was going to be to tighten the bolts holding the coupler together. It was really awkward and hard. Took 2 people. (one turning the motor, the other holding the allen wrench.)
This was compouned when we discovered another alignment problem. Turns out that the end bells of the Impulse 9 motors aren't that accurately machine. We had a 10-20 thousandths variance between them that we had to shim.
|
|
Getting ready to put on the Flywheel adapter2709 viewsThe Flywheel adapter is also a heated press-fit. We made sure we had spacers to keep it from going on the shaft too far.
|
|
Flywheel adapter is on!3785 viewsCooling it down after pressing it on to the shaft. (more like setting it on, and tapping it gently down.)
|
|
Flywheel and cluth mounted3619 viewsBolted things together, bolted on the flywheel and clutch assemblies.
|
|
Motor and Transmission4232 viewsHere is the full drive assembly. Both Impulse 9 motors, transmission and transfer case.
We are going to lift it into the truck from the bottom.
|
|
Shop2819 viewsCenter aisle/work area. Currently has a motorcycle and tablesaw sitting there.
|
|
Motor-Motor mount ends3212 viewsWe started with some scrap plate steel from the local recycle place.
|
|
Motor-Motor mount body2342 viewsAnd a piece of old iron pipe from the same place.
|
|
Motor-Motor mount rough2470 viewsHere is the mount after some work in the lathe on both the raw pieces.
|
|
| 39 files on 4 page(s) |
1 |
 |
|
