Painted Motor Mount7975 viewsI then sandblasted it all ,and painted it.Feb 21, 2009
|
|
Building Motor Mounting Framework9520 viewsWe decided it was easiest to juts build the motor mounting framework in place. Carefully cut pieces and clamp them in place, then tack weld it all together.
Feb 21, 2009
|
|
Position motors10476 viewsMotors were mounted to the transmission, then lifted in from below.
Transmission was then bolted to it's mounts, and the motors placed on blocks to keep everything in positionFeb 21, 2009
|
|
Pulling the engine11367 viewsRemoving the 460cui gas engine. (Having a forklift really made this easier.)
All 762 pounds of it!
Feb 13, 2009
|
|
Motor-Motor mount finished3087 viewsPainted all prettyFeb 13, 2009
|
|
Motor-Motor mount drilled2374 viewsMounting holes drilled and primer applied.Feb 13, 2009
|
|
Bigger holes in the Impulse 92147 viewsWe decided that the rather small bolt holes in the end bells of the Impulse 9" motors were just too small.
So we drilled and tapped all of them out to a 7/16" bolt thread.Feb 13, 2009
|
|
Motor-Motor mount test fit2578 viewsHow it fits on one of the motors.Feb 13, 2009
|
|
Motor-Motor mount welded2217 viewsHere is the mostly finished mount all welded together.Feb 13, 2009
|
|
Motor-Motor mount access holes2442 viewsIt was interesting putting the access holes in the mount.Feb 13, 2009
|
|
Motor-Motor mount rough2452 viewsHere is the mount after some work in the lathe on both the raw pieces.Feb 13, 2009
|
|
Motor-Motor mount body2325 viewsAnd a piece of old iron pipe from the same place.Feb 13, 2009
|
|
| 867 files on 73 page(s) |
 |
|
|
|
|
25 | |
|
|
|
|
