Putting them together3433 viewsBoth motors together! Bolted to the motor-motor mount. (1 votes)
|
|
Coupler almost off3313 viewsThis is the coupler when it's just about cut off.
We would cut down to the keyway in the coupler, then we could pry it open just enough to tap it off the shaft.
(1 votes)
|
|
Finished and drilled couplers3464 viewsThis is the finished coupler assembly with all the screws that will be used to hold them together. (1 votes)
|
|
Finished Coupler3679 viewsThe finished coupler. (Well, I did have to have 2 keyways cut into it, and drill some holes for set screws after this.) (1 votes)
|
|
Truck as purchased6022 viewsThis is the truck when I got it home. At this time, it does NOT have a transmission.
It weighs 5940 lbs. (It does have some amount of Gas, and a big toolbox)
First thing I did after getting it home was --- break the ignition switch. sigh. I had to drill it out and replace it. (1 votes)
|
|
Range Extender Genset on Sparrow4268 viewsThis was my 1st attempt at mounting the Genset. Turned out to hang a little too low with both me and the Genset. It would hit the ground when going over big bumps. (1 votes)
|
|
|
|
Underseat Battery box with 65 NiCd cells installed3522 viewsThis is with all the cells connected with Busbars. (1 votes)
|
|
Battery Boxes4053 viewsBattery Boxes just after painting (1 votes)
|
|
|
|
53 files on 5 page(s) |
|
3 | |
|