Finished and drilled couplers3464 viewsThis is the finished coupler assembly with all the screws that will be used to hold them together.
|
|
Finished Couplers and Flywheel mount2501 viewsThese are the finished couplers and the Flywheel mount.
|
|
Starting the 2nd version of the Motor Coupler2497 viewsAfter our near-disaster with the 1st motor coupler, we decided to build the new one as a 2 piece unit. This will allow the motors to be separated if needed.
|
|
Motor coupler work2313 viewsContinuing work on the coupler
|
|
Boring coupler shaft holes2252 viewsThis time we wanted to be SURE our boring bar wouldn't flex, so we built a much stronger one.
We also are using much better cutting tips.
|
|
Shortening the coupler2230 viewsWe did start with a piece of shaft that was too long, and decided it would be easier to cut off the excess with a saw, rather than cutting it all away with the lathe.
|
|
|
|
|